Past Events

Please click the event heading for further information.
  • Event Type: Professional development event
    08 October 2021 11:00 to 23 October 2021 12:00
    Virtual Event, South East Asia
    Open to all South East Asia based engineers and technicians This webinar is a general introduction to IMechE and its professional registration route for membership. The timing of this webinar will be conducted on GMT +8 (Malaysia, Singapore, Brunei)
    Industry: Cross-sector
  • Event Type: Conference
    03 October 2021 09:00 to 06 October 2021 17:00
    Webinar (no physical venue) - .
    The Centre of Environment and Green Technology (CEGT), Universiti Tunku Abdul Rahman (UTAR) is pleased to announce the organization of the 4th International Symposium on Green and Sustainable Technology 2021 (ISGST 2021) which shall take place VIRTUALLY from Universiti Tunku Abdul Rahman, Kampar, Perak, Malaysia on the 3rd – 6th October 2021.
    Industry: Cross-sector
  • Event Type: Technical lecture
    30 September 2021 15:00 to 16:00
    Monash University Malaysia (via Online Platform - Zoom) - Petaling Jaya
    Interested to implement acoustic solutions without compromising the design and the beauty of the building? In this talk, we will discuss the importance of acoustics and architectural designs, and how design could impact acoustics. Join us to learn about the key strategies on achieving an optimum balance between these components.
    Industry: Automobile
  • Event Type: Technical lecture
    28 September 2021 09:45 to 12:00
    Webinar (no physical venue) - .
    In collaboration with IMechE Monash University Malaysia Student Chapter, IMechE Malaysia will be organising the below Webinar. BEM CPD hour is pending for approval.
    Industry: Cross-sector
  • Event Type: Technical lecture
    28 September 2021 09:45 to 12:00
    Monash University Malaysia (via Online Platform - Zoom) - Petaling Jaya
    When selecting bearings for any purpose, ultimately we want to be certain of achieving the required level of equipment performance, and robustness, at the lowest possible cost. There are key factors we must consider when putting together the bearing specifications for an application. Bearing general knowledge and Bearing selection process are two main critical factors needed for this purpose. Basic selection principles must be applied in order to achieve the desired performance.
    Industry: Automobile
Page 2 of 102
<< 1234567 >>


© 2011 Institution of Mechanical Engineers. IMechE is a registered charity in England and Wales number 206882